Views:

Pre-Requisites

  • USB Drive Preparation: Save the software file (e.g., EPSXXXXXXrev00.bin) directly to the root of the USB stick. 

     

  • Important: Do not save the software file inside a folder on the USB drive. 

     

Step-by-Step Instructions

1. Controller Preparation

  • Remove the USB screw cap on the controller to reveal the USB port. 

     

  • Power ON the controller. 

     

     

 

 

2. USB Connection

  • Insert the USB stick and wait for the screen to change automatically. 

     

  • Troubleshooting: If the screen does not change, remove the USB stick, power cycle the controller (turn off and on), and repeat the insertion. 

     

3. Software Selection

  • The USB Memory screen will appear. 

     

  • Use the Arrow Keys to move the pointer and select the correct .bin software file. 

     

    • Note: Only one software option may appear depending on what is stored on the drive. 

       

  • Press 'Enter' to begin the upload or 'ESC' to cancel. 

     

4. Upload Process

Once initiated, the following screens will appear automatically in sequence: 

 

  • Screen 1: "Boot Loader - Erasing Memory" 

     

  • Screen 2: "Boot Loader - Programming Flash - Bytes Uploaded" 

     

  • Screen 3: "Boot Loader - [Hexadecimal Address] - Bytes Uploaded." The numbers will change dynamically during this phase. 

     

5. Finalizing the Upload

  • If the USB Memory screen reappears after the upload, press 'ESC'. 

     

  • Once the Home Screen (displaying manual controls and RPM) appears, it is safe to remove the USB stick. 

     

 

Warning: Do not remove the USB drive while the "Boot Loader" screens are active or while software numbers are changing.

 

 

Keywords: Expert Plus 2, USB, uploading, instructions, software, BIN file, EPS, root, controller, USB port, power cycle, boot loader, erasing memory, programming flash, bytes uploaded
Related Products: 1400-V Autowrap, Q200-V Autowrap, Q300-V Autowrap, S200-V Autowrap, S300-V Autowrap