There are a number of wear plate options available for the Autocut Range, some for additional protection and others to increase the cutting height. See below:
CAM00238 [Cutter Bar Wear Plates] are 6mm think and add additional protection to the mower bed from general wear and tear. Each module requires a skid (ie. M10 x9, M9 x8, M3 x7).
The part highlighted in blue in the image above is the Cutter Bar Wear Plate (CAM00238)
CAM00327 567 Cutterbar Skid (H30mm)
CAM00327 acts as a skid to raise the highet of the mower bed to allow for accurate cutting at a set height of 50mm. The skids should be placed on each module (ie. M10 x9, M9 x8, M3 x7).
CAM00327 567 Cutterbar Skid (H30mm)